![Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump() Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump()](https://blog.honzamrazek.cz/wp-content/uploads/2022/01/bitmap-1-1024x640.png)
Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump()
![Are resin prints feel more “tacky” than FDM filament print in general? I've cured these two for 2 hours but still feeling a little bit sticky. : r/3Dprinting Are resin prints feel more “tacky” than FDM filament print in general? I've cured these two for 2 hours but still feeling a little bit sticky. : r/3Dprinting](https://i.redd.it/1qci40eira281.jpg)
Are resin prints feel more “tacky” than FDM filament print in general? I've cured these two for 2 hours but still feeling a little bit sticky. : r/3Dprinting
![Model not sticking to supports & first layer issues – Assembly and first prints troubleshooting – Prusa3D Forum Model not sticking to supports & first layer issues – Assembly and first prints troubleshooting – Prusa3D Forum](https://forum.prusa3d.com/wp-content/uploads/2021/05/IMG_0825.jpg)
Model not sticking to supports & first layer issues – Assembly and first prints troubleshooting – Prusa3D Forum
![I ordered a 3D printed resin statue from someone and the base was cracked open and the entire base was coated in a slimy and sticky substance. I assume it's resin? The I ordered a 3D printed resin statue from someone and the base was cracked open and the entire base was coated in a slimy and sticky substance. I assume it's resin? The](https://i.redd.it/lxu22m6vwiob1.jpg)
I ordered a 3D printed resin statue from someone and the base was cracked open and the entire base was coated in a slimy and sticky substance. I assume it's resin? The
![Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump() Prints not sticking to the build plate, layer separation, rough surface, elephant foot: resin viscosity – the common denominator – mind.dump()](https://blog.honzamrazek.cz/wp-content/uploads/2022/01/failures-1024x562.jpg)